|
The two coils sitting apart.
The larger coil is the conditioning coil and the smaller
coil is the resonant coil. The resonant coil is to used
to put the magnets into a resonant state. The magnets sit
on the larger conditioning coil to get the resonant frequency.
The next picture shows how
the larger conditioning coil goes over the smaller resonant
coil.
This picture shows the smaller resonant
coil inside the larger coil.
|
SQM Magnets.
The magnets that I have are bought are from
http://www.magnet.au.com/.
They are Anisotropic barium ferrite magnets and
measure 100mm x 150mm x 25mm. I am currently using
PCV tube 100mm x 150mm x 50mm as the holder.
|
|
The current size of the wire is 1.5 mm and it might be to big for the Amplifier to give it the correct wave form efficiently. A new roll of no# 15 gauge wire will be purchased this week and wound on to the spool. The Impendence is a bit low also. 3.2 Ohms and Floyd mentions in the video that it is supposed to be 4 Ohms. The large coil is pulsing nicely. I currently have a step down transformer with an output at 120 Volts 60 Hz pulsing into the Large coil. The wave form is not yet what I am wanting to achieve. My basic circuit needs some improvements. The size of the wire on the large coil is currently 1.5mm and measures 1 Ohm. I am currently thinking this coil might need to be Bifilar instead of just the single filer coil I currently have. I am currently testing field strength versus wire size and impedance. More work will be done tomorrow and Pictures will be posted.
|
|
